1600M engine mountingsize.
Discussion
Hi folks I'm after some help from someone with a 1600M to take a few measurements for me.
I have an early 1600M which has had it's engine mounting brackets removed from the chassis and I would like to put them back. The gearbox crossmember chassis brackets are missing too.
I have the original engine and gearbox, so really just need to confirm that it's in the correct position before I weld in the new mounts.
The measurements I need are:
the distance between the vertical block face beside the water pump forward to the top chassis crossmember.
the height of the crank centre or sump above the notched lower crossmember.
the height between the cast iron top face of the gearbox (4 speed) just behind the bellhousing up to the horizontal body seam above the heater plenum.
I would be much obliged if anyone is willing to do this.
Thanks.
I have an early 1600M which has had it's engine mounting brackets removed from the chassis and I would like to put them back. The gearbox crossmember chassis brackets are missing too.
I have the original engine and gearbox, so really just need to confirm that it's in the correct position before I weld in the new mounts.
The measurements I need are:
the distance between the vertical block face beside the water pump forward to the top chassis crossmember.
the height of the crank centre or sump above the notched lower crossmember.
the height between the cast iron top face of the gearbox (4 speed) just behind the bellhousing up to the horizontal body seam above the heater plenum.
I would be much obliged if anyone is willing to do this.
Thanks.
Gassing Station | TVR Classics | Top of Page | What's New | My Stuff