Discussion
Hi fellas,
I was getting some intermitent boost recently so I purchased a new boost solenoid from GM. As I started the car this evening to get it out of the garage it ran really lumpy and struggled to idle. Then it cut out. This happened again. Then it would fire up and immediately cut out.
I can hear the fuel pump priming when I turn the key to the start point so I assume it's getting fuel. I don't have any ideas so wondered if any of you guys could help?
James
I was getting some intermitent boost recently so I purchased a new boost solenoid from GM. As I started the car this evening to get it out of the garage it ran really lumpy and struggled to idle. Then it cut out. This happened again. Then it would fire up and immediately cut out.
I can hear the fuel pump priming when I turn the key to the start point so I assume it's getting fuel. I don't have any ideas so wondered if any of you guys could help?
James
have you messed around with the vac pipes that go on the inlet manifold? make shure you havnt pushed the biggest one on all the way,check by pushing on it,if it doesnt move then its on too far .pull it back a bit,so you arnt blocking the end.bell me if you have a prob.07723027282 tony
Gassing Station | Noble | Top of Page | What's New | My Stuff




