Discussion
joust said:
4 screws and the pullling off of two spade connectors and sticking them back on per side.
Blimey -I think even I might be able to manage that!
Current Sony speakers are wonderful - great aural tone, full range, crystal clear blah blah..and then you turn on the engine and can hear sod all!
You need to pull out the mesh, either with a pin type thing or a knife at the ende, the mesh if fitted into a slot round the edge of the base plate.
Very easy to swop over.
I fitted an infinity 3 way speaker that sounds a lot better, but remember that you are never going to get it to sound very good in a GRP door with little insulation or space and only 1 speaker each side.
The OEM units are poor though, as are sony head units. (they sound very tinny, the way Japaneese like it I guess)
Greg
Very easy to swop over.
I fitted an infinity 3 way speaker that sounds a lot better, but remember that you are never going to get it to sound very good in a GRP door with little insulation or space and only 1 speaker each side.
The OEM units are poor though, as are sony head units. (they sound very tinny, the way Japaneese like it I guess)
Greg
Mr Noble said:
You need to pull out the mesh, either with a pin type thing or a knife at the ende, the mesh if fitted into a slot round the edge of the base plate.
Very easy to swop over.
I fitted an infinity 3 way speaker that sounds a lot better, but remember that you are never going to get it to sound very good in a GRP door with little insulation or space and only 1 speaker each side.
The OEM units are poor though, as are sony head units. (they sound very tinny, the way Japaneese like it I guess)
Greg
Greg, so maybe this is where I've been going wrong! You say extract just the mesh and not the Black plastic bezel (In the past I've tried levering off the bezel!)?
Gassing Station | Noble | Top of Page | What's New | My Stuff




) 