Springs and Dampers

[Steve_D]

Looking for guidance on replacement springs and dampers.
I actually need them for an M10 but suspect the M12 will be pretty much the same.

Thanks in advance.

Steve

[maserati3200gt]

Hi i read the chimaera advise and noticed you had a wire diagram for the car. Mine is a 1996 4.0. If you still have it i would be grate full for a copy. It says PM you but im not sure how to do that. Thanks Edd

[TuxMan]

Hi Steve , you can purchase spring and damper sets for the M12 from Protech shocks , the bolt patterns are 1/2” UNF on the lower wishbone and m12 on the top chassis mount . Is this the same on the M10 .

[Steve_D]

maserati3200gt said:

Hi i read the chimaera advise and noticed you had a wire diagram for the car. Mine is a 1996 4.0. If you still have it i would be grate full for a copy. It says PM you but im not sure how to do that. Thanks Edd

Click on my name which will take you into my profile. Top right click on 'email me'.

Steve

[Steve_D]

TuxMan said:

Hi Steve , you can purchase spring and damper sets for the M12 from Protech shocks , the bolt patterns are 1/2” UNF on the lower wishbone and m12 on the top chassis mount . Is this the same on the M10 .

Hi simon, I think these are 1/2" top and bottom but I doubt that will be an issue with Protech as I expect them to be made to order. There aren't even enough M12 to warrant them having sets sitting on the shelf. I will give them a call.
I read a number of posts where you and others were playing with spring rates. Did this resolve into a preferred rate for road use?

Steve

[TuxMan]

Hi mate , 475lb fronts and I think something like 600 rears , cannot remember for sure . Protech should be able to sort that as well !