Alternator issues

Alternator issues

Author
Discussion

Hawkinsster

Original Poster:

171 posts

182 months

Thursday 19th October 2017
quotequote all
Does anyone know the effort of changining one of these? Is it in an accessible location? My battery isnt charging at certain revs (when i boot it) left in garage for a week and now flat. #joy

TuxMan

9,011 posts

245 months

Sunday 22nd October 2017
quotequote all
Pretty difficult to do with the battery in place !! Basically you remove drivers wheel plus arch infil , drop battery out the bottom then you should be able to get it off ! Not easy but I've done it twice . Is it the original alternator ?
Ford have stopped using brand new units and now supply re-engineered units so I would not bother paying the xtra !! Jetstream supplied my last unit .

Hawkinsster

Original Poster:

171 posts

182 months

Tuesday 24th October 2017
quotequote all
Hi Tux,
Thanks for the reply.
I actually got it started by charging the battery. After taking it out for a drive - the battery light only comes on after 4,000 rpm so i think sunmits loose. I am in contact with Jestream who are assisting me - just trying to avoid the jounrey up there.

Midlifecrisis71

2,871 posts

282 months

Saturday 28th October 2017
quotequote all
Mine failed, I replaced with a ford unit, turns out a re-engineered one, failed within 2 months in a similar way to the behaviour your describing. Problem is after a while of flickering light, my speedo got fed up with the voltage changes and sulked. Then the lights were dim/bright/dim bright on a drive back from the ferry one night. It had to be replaced (I did the first one myself, its a bh without ramps) second one I got SWLotus Centre to do it for £280 labour !
Read what you will in to that.

dave sutton

213 posts

155 months

Wednesday 13th December 2017
quotequote all
I have just had a faulty alternator replaced too. In the course of which, it emerged that the alternator feed went to the wrong side of the 80amp fuse. In other words, any alternator/regulator fault leading to an over voltage could potentially fry much of the loom/ecu etc!

Mine has been redirected to the upside of the 80amp fuse. Suggest anyone reading this checks their wiring and adjusts if necessary.