Noble without ecu upgrade?

Noble without ecu upgrade?

Author
Discussion

hampytvr

Original Poster:

61 posts

122 months

Wednesday 16th March 2016
quotequote all
Looking at buying a low mileage noble that hasn't had the ecu upgraded. Will this have to be done or could it turn out to be reliable as as it hasn't needed doing yet? How much does an upgrade cost?
Thanks

TuxMan

9,011 posts

245 months

Wednesday 16th March 2016
quotequote all
Has it got the magnetti merreli fitted ?

hampytvr

Original Poster:

61 posts

122 months

Wednesday 16th March 2016
quotequote all
Not sure why? Is that the original factory fit?

stevegto3

428 posts

144 months

Wednesday 16th March 2016
quotequote all
What is it, a 2.5 GTO, GTO3 or 3r?

2.5s had the old ecu as did very early 3s. Anything beyond had MBE ecu, which is fine.

hampytvr

Original Poster:

61 posts

122 months

Wednesday 16th March 2016
quotequote all
it is a 2002 2.5 that went back to the factory in 2003 to have the engine upgraded to a 3L.

stevegto3

428 posts

144 months

Thursday 17th March 2016
quotequote all
Are you sure they didn't do the ecu at the sametime as I believe the old 2.5 ecu wouldn't work on the 3.0. I maybe wrong on that point.

Bottom line if it is still the really old ecu then they were prone to failure. Jetstream I believe has the latest mbe Ecus but they are not cheap.

TuxMan

9,011 posts

245 months

Thursday 17th March 2016
quotequote all
More than likely it's been upgraded to the 3 litre MBE system , the latest MBE ecu is available from Jetstream if you wish to upgrade , cost is 1k plus .

Tuscanny

215 posts

133 months

Thursday 17th March 2016
quotequote all
Hi 975B should be on the ecu box. If touch look in the drivers side rear arch you should see it.

Chapppers

4,483 posts

198 months

Thursday 17th March 2016
quotequote all
sounds like a fun ownership prospect...

M12 Ryan

32 posts

106 months

Thursday 17th March 2016
quotequote all
Hi you can only see the ecu if you take of the cover in front of the rear wheel, but if you look at the loom where it comes up from there towards engine mine had a tag on it that states mbe loom on it, you may need to give it a clean to see it.

hampytvr

Original Poster:

61 posts

122 months

Thursday 17th March 2016
quotequote all
Thanks all, really helpful!
Sorry I was too late to buy yours chapped, too slow selling my tiv.

dave sutton

213 posts

155 months

Monday 21st March 2016
quotequote all
I have an ecu that was on my 2.5 and which has 975B in its part no. and 'green dot' stamped on the label whatever that means. PM me if interested.