Carbon end plates and m.o.t

[rsrob1]

Car is due its m.o.t and it has what I believe to be tuxman end plates, sure I have read on an old thread that these need a trim fitting to the edges to pass? If so what have people used? Cheers Rob

[mgbond]

I doubt they would say anything

[Blu3R]

If you're that bothered just unbolt them before the test.

[TuxMan]

Should be fine , never had a problem in the past .

[rsrob1]

cheers for the replies sounds like its not a problem

[TuxMan]

I have got some rubber edging if you go to the ring , that is the only place you might need it . Send me your address I will pop you some in the post .

[JW027]

MOT'd mine a month ago with raw carbon end plates and this didn't come up at all. I wouldn't worry about it.

[wessexrfc]

Just had mine MOT'ed with the Tuxman diffuser fitted and no problems with either.

[GTO600]

wessexrfc said:

Just had mine MOT'ed with the Tuxman diffuser fitted and no problems with either.

Paul does that mean it's alive & running again ?

[wessexrfc]

GTO600 said:

wessexrfc said:

Just had mine MOT'ed with the Tuxman diffuser fitted and no problems with either.

Paul does that mean it's alive & running again ?

Just waiting on a time to get into Track & Road, looking like next Thursday abw. I have forgotten what it looks like!!!

[TuxMan]

Great news mate !!! Good luck on the dyno !