2.5 L bottom end re-furb??

[2.5bluenob]

I'm going to drop my engine out on my 2.5 L and looking to inspect my bottom end. I'm not sure how far i'm going take it as regards to forged pistons etc. or just to upgrade bearings etc. can any one recommend where to get the work done or a supplier of the parts i would need?
Also what sort of things are people doing the bottom end with regards to what parts to upgrade etc???

Thanks
Steve

[GTO600]

Noble Motorsport ask for Mike.

[TIGERSIX]

GTO600 said:

Noble Motorsport ask for Mike.

+1 top blokes always done me proud Mike is a good bloke.

[2.5bluenob]

Yeah ok chaps. was thinking about them, ive used them in the past for ecu upgrade and bits and they are good blokes and very helpful.
Maybe ill give them a call next week.

[Gadgeroonie]

you might want to fit a 3.0 instead - it will fit ok

[mgbond]

Bottom end is all upgraded bearings (all bolts are ARP already) and maybe lighten fly wheel and balance it all.

That's what I did.

Bondy

[2.5bluenob]

mgbond said:

Bottom end is all upgraded bearings (all bolts are ARP already) and maybe lighten fly wheel and balance it all.

That's what I did.

Bondy

Hi bondy, do you mean already has upgraded bearings etc as standard??
flywheel is already lightened as i did it last time round.
steve

[mgbond]

No, I mean u need to upgraded all the bottom end bearings. Don't upgrade the bolts as these are already ARP.

Email me and I'll send u spread sheet that has part numbers.

[e-mail]

[2.5bluenob]

Bondy
PM sent.