Lifting car off ground
Discussion
I useally reverse mine up a couple of bits of 4x2 to get it a couple of inches higher, slide trolley jack in the centre from behind making sure to place jack under chassis where the fibre glass meets the Ali sheet, use a piece of timber on the jack to protect the floor, jack it up slowly and place blocks or timber under the rear wheels as u go...make sure u put something under the front wheels 2 stop it sliding forward.
This should give u enough room 2 slide under as far a the bulk head.
Someone on here did make some ramps, may be I should knock some up and sell them to you guys!!
Good luck!!
This should give u enough room 2 slide under as far a the bulk head.
Someone on here did make some ramps, may be I should knock some up and sell them to you guys!!
Good luck!!
couple of bits of timber is the cheapest option.
But also if you have a scisssor jack i used to put this undser the front jacking point, list the car up an inch, then get a normal jack under the rear, you will see a rounded nub located about 1tf infront of the rear wheel, jacking up at this point will lift the entire side of the car...
Then stick a stand under the front and rear wishbones or uprights for safety.
But also if you have a scisssor jack i used to put this undser the front jacking point, list the car up an inch, then get a normal jack under the rear, you will see a rounded nub located about 1tf infront of the rear wheel, jacking up at this point will lift the entire side of the car...
Then stick a stand under the front and rear wishbones or uprights for safety.
Gassing Station | Noble | Top of Page | What's New | My Stuff




