360 clutch question

[Simon T]

I need a new clutch position sensor.... Bummer as its inside the bell housing. So whilst the box is off it makes sense to get a new clutch fitted. I was wondering if a CS clutch would fit and if it did would it makes any improvement over a standard 360 spec item?

Simon

[Cerberaherts]

No difference. Incidently, you don't need to remove the gearbox to change the clutch sensor. You can take off the two small steel pipes from the slave and change it through the hole . Takes about an hour and a half...

[Simon T]

Cerberaherts said:

No difference. Incidently, you don't need to remove the gearbox to change the clutch sensor. You can take off the two small steel pipes from the slave and change it through the hole . Takes about an hour and a half...

Interesting, thanks for that bit of info! Will discuss with the dealer tomorrow