Removing door trim from Fiat Ducato
Discussion
I'm trying to replace the driver's side wing mirror on my Fiat Ducato-based motorhome. I have removed the wing mirror but I can't pull the cable through to allow me to disconnect the old mirror and connect up the new one.
I think I need to remove the door trim on the inside to be able to access the connector and finish the job but I can't see a way of getting the trim off.
Can anyone help me with this?
Many thanks!
I think I need to remove the door trim on the inside to be able to access the connector and finish the job but I can't see a way of getting the trim off.
Can anyone help me with this?
Many thanks!
size13 said:
what year van?
2010.Figured it out. All I needed to do was to remove the speaker which allowed me access to the connection that I needed. I had also removed the window/mirror controls although it would have probably been possible to access the connection without doing so.
Job is a good one, and a lot cheaper than the £600 the local Fiat dealer wanted to charge me!
slf2012 said:
2010.
Figured it out. All I needed to do was to remove the speaker which allowed me access to the connection that I needed. I had also removed the window/mirror controls although it would have probably been possible to access the connection without doing so.
Job is a good one, and a lot cheaper than the £600 the local Fiat dealer wanted to charge me!
Good stuff - although ours is a 1990 Ducato, when I was looking to do the same I found loads of instructions for newer models.Figured it out. All I needed to do was to remove the speaker which allowed me access to the connection that I needed. I had also removed the window/mirror controls although it would have probably been possible to access the connection without doing so.
Job is a good one, and a lot cheaper than the £600 the local Fiat dealer wanted to charge me!
Gassing Station | Tents, Caravans & Motorhomes | Top of Page | What's New | My Stuff