Battery Vent Plug
Author
Discussion

Andy 308GTB

Original Poster:

3,053 posts

251 months

Monday 21st September
quotequote all
Mr. Google got me nowhere.
New Yuasa battery, I'm convinced that the plug in the pictures should be removed. It came out very easily and is quite flimsy.
When I have had batteries with vent plugs previously there have been clear instructions that they should be removed but nothing in the accompanying document or on the Yuasa website. A recent Reddit thread had varying opinions but I suspect there was a bit of trolling going on, the trolls were insisting that it should be retained.
Whatever, I've removed it but I'm interested on what the forum thinks.
I'm now arguing with a well known online battery retailer about the failure of the 4 month old battery. No parasitic leak found following a (lengthy & not inexpensive) test by a good auto electrical company.



x type

1,020 posts

220 months

Monday 21st September
quotequote all
You are correct to remove it good old google says as below

plus I bought a new battery for my x type recently and was told remove red breather , the battery needs to breathe

https://www.google.com/search?client=firefox-b-d&a...



Vent Plug RulesEngine Bay Location: If your Yuasa battery sits in an open engine bay, remove transit plugs from both sides (or ensure the built-in labyrinth/side vents are clear) so the battery breathes freely to the atmosphere

Boot or Cabin Location: If the battery is mounted inside the vehicle interior or boot, insert a blanking plug into one vent hole and connect your vehicle's flexible rubber extraction/breather pipe to the other vent hole.Never Seal Both Sides: Never leave red transit caps fully blocking an active vent side during use, as trapped hydrogen gas build up can cause the casing to rupture or explode.

Andy 308GTB

Original Poster:

3,053 posts

251 months

Monday 21st September
quotequote all
Thanks.
I assumed, wrongly, that my Google search skills were OK...
I find it odd that that the battery didn't have something on it, that's my excuse & I am sticking to it!

Smint

3,619 posts

65 months

Wednesday 23rd September
quotequote all
Whenever i've bought from Tayna there's usually labels attached informing you to remove the plugs.

Andy 308GTB

Original Poster:

3,053 posts

251 months

Wednesday 23rd September
quotequote all
Smint said:
Whenever i've bought from Tayna there's usually labels attached informing you to remove the plugs.
This is the replacement battery which came from my local motor factor - which was actually £5 cheaper than Tanya.

Sheepshanks

41,066 posts

149 months

Wednesday 23rd September
quotequote all
x type said:
Vent Plug RulesEngine Bay Location: If your Yuasa battery sits in an open engine bay, remove transit plugs from both sides (or ensure the built-in labyrinth/side vents are clear) so the battery breathes freely to the atmosphere

Boot or Cabin Location: If the battery is mounted inside the vehicle interior or boot, insert a blanking plug into one vent hole and connect your vehicle's flexible rubber extraction/breather pipe to the other vent hole.Never Seal Both Sides: Never leave red transit caps fully blocking an active vent side during use, as trapped hydrogen gas build up can cause the casing to rupture or explode.
My 2005 Merc combined those - the battery was under the bonnet, but separated from the engine by sheet metalwork, so it was more like it was part of the scuttle area. There was a battery drain tube from one of the vents through the base of the compartment.

renmure

4,929 posts

254 months

Wednesday 23rd September
quotequote all
By coincidence I had a new battery delivered today and the external box and all the internal plastic was plastered with labels saying "Immediately remove the transit plugs" when unpacking.