Demister broken tab

[daveenty]

Was going to put this in GG for the masses though, reckoning it'd get moved here anyway, thought I'd save the mods a job.

Jeep heated rear window. Basically two tabs, one either side, allow spade connectors to slide in to supply a power source. Unfortunately, one of these tabs has broken off. It was held on with tape when I got it though I've no idea if it worked or no, but now I've removed all the tape, glue, snot and whatever else was holding it together. I need a permanent solution but can't figure out how to attach the connector to the glass. Obviously superglue or similar should hold it, but as far as I'm aware, it's non conductive.

Any suggestions please?

[mattyc69]

http://www.speeding.co.uk/cgi-bin/sh000069.pl?REFP... scroll to the bottom of the page, you can buy me a pint later ;-) I have used this stuff and works perfect if a little expensive.

Edited by mattyc69 on Thursday 10th July 21:58

Edited by mattyc69 on Thursday 10th July 21:59

[daveenty]

Cheers Matty, much appreciated, though is this just not the conductive paint?

I need a glue or something to stick the connector back onto the window as it's just dangling there at the moment.

[mattyc69]

This stuff is rubbish at repairing the actually joints in the window as it's too sticky! So makes it perfect for sticking the connectors back on. Get it warm give it a good shake and plonk loads on and it will do the job.