hi everyone!(expecting help)(sti 2004)

hi everyone!(expecting help)(sti 2004)

Author
Discussion

viktor m

Original Poster:

8 posts

143 months

Monday 19th November 2012
quotequote all
excuse me for my english!my location Ukraine Kiev. i ve got my engine bay burned up(any solutions?)
pleased to talk with a good judge(sublovers)
tnks!

Edited by viktor m on Tuesday 20th November 13:48

ScoobieWRX

4,863 posts

232 months

Monday 19th November 2012
quotequote all
Мы понятия не имеем, как плохо повреждения без картинок. Вы можете делать снимки, вы можете отобразить на этом форуме, и тогда мы можем проконсультировать Вас.

(We have no idea how bad the damage is without pictures. You can take pictures, you can display on this forum, and then we can advise you.)

paulmoonraker

2,850 posts

169 months

Tuesday 20th November 2012
quotequote all
hehe gotta see the outcome of this wink

ScoobieWRX

4,863 posts

232 months

Tuesday 20th November 2012
quotequote all
New engine bay wiring loom and new cabin wiring loom to make engine run.
Новый моторный отсек проводка ткацкий станок и новые жгут проводов кабины, чтобы сделать запуска двигателя.

New engine wiring loom.
Новый жгут проводов двигателя.

Maybe new ECU if it got hot.
Может быть, новые ECU, если она стала горячей.

New fuel lines repaired from inside left wing cavity.
Новые линии топливо отремонтировали внутри полости левого крыла.

New engine.
Новый двигатель.

Respray.
перекрашивание

It's a lot of work and maybe not worth it. Surely it must be cheaper and less work to just get another car. If not then you must be desperate.
Это большая работа и, возможно, не стоит. Конечно, это должно быть дешевле и меньше работы, чтобы просто получить другую машину. Если нет, то вы должны быть в отчаянии.

ScoobieWRX

4,863 posts

232 months

Tuesday 20th November 2012
quotequote all
paulmoonraker said:
hehe gotta see the outcome of this wink
I think it's foolishness just to even contemplate it. That's a right off if ever there was one. The car is too old and not worth it for the cost involved not to mention bodywork, respray etc...etc...



paulmoonraker

2,850 posts

169 months

Tuesday 20th November 2012
quotequote all
its a trolling FAIL wink

ScoobieWRX

4,863 posts

232 months

Tuesday 20th November 2012
quotequote all
You might be right hehe

viktor m

Original Poster:

8 posts

143 months

Wednesday 21st November 2012
quotequote all
my suggestion to buy a wrecked car without rear part, just front, and take all needed parts ?
here in Ukrain to fix it will cost me about 6-7$(only parts)/1.5-2$ work! in kiev price of the car 17-19$, i can sell it 7-8 in these condition !
i am desperate!

paulmoonraker

2,850 posts

169 months

Wednesday 21st November 2012
quotequote all
Like a cut and shut - that's a good idea. Can you weld?

viktor m

Original Poster:

8 posts

143 months

Wednesday 21st November 2012
quotequote all
i dont need to weld it my spars are allrigt . i just need front bumper\hood\engine bay containing-engine is ok-oil seal\gaskets... transmission...

paulmoonraker

2,850 posts

169 months

Wednesday 21st November 2012
quotequote all
But it will be easier to cut your old car in half, find a decent front-end from another car (doesn't have to be a scooby - a mini, VW beetle?), then just weld the two together. You can just use tape for the prop shaft etc, it'll hold...

viktor m

Original Poster:

8 posts

143 months

Wednesday 21st November 2012
quotequote all
any solutions where i can find a necessary front part?

cheesesliceking

1,572 posts

246 months

Wednesday 21st November 2012
quotequote all
I think he means he needs a front clip, ( the whole front part from firewall onwards is cut from donor car = front clip)

It's easier to buy the whole front clip with all the parts on, remove the parts and fit to original car, don't think he means to cut and weld the whole front clip section from a donor car to the original car.

Of course, i could be wrong smile

Most breakers will suplpy front clips, Now i dont really know any Impreza breakers so I cant suggest any, but i think Victor wants to know of some decent UK breakers as where he comes from the parts are very expensive, if anyone knows of any??

http://www.scoobybits.co.uk/carsforsale_breakers.h...

no idea if these guys are good or not.

hope this helps smile

viktor m

Original Poster:

8 posts

143 months

Wednesday 21st November 2012
quotequote all
can you help me with approximate price of front clip?

viktor m

Original Poster:

8 posts

143 months

Wednesday 21st November 2012
quotequote all
can you help me with approximate price of front clip?

jimmyboy85

380 posts

154 months

Wednesday 21st November 2012
quotequote all
Can't see the problem really, bit of filler and it will be good as new.

pidsy

8,151 posts

163 months

Wednesday 21st November 2012
quotequote all
any more pics viktor?

paulmoonraker

2,850 posts

169 months

Wednesday 21st November 2012
quotequote all
jimmyboy85 said:
Can't see the problem really, bit of filler and it will be good as new.
I agree, I think he has 'over cooked' this problem hehe

viktor m

Original Poster:

8 posts

143 months

Wednesday 21st November 2012
quotequote all
i realy count on you guys, cause everyony here wanna fk me ! prices are realy high!!! my budget is pretty small about 5-6 k ....depend on your knowledge! unfortunatly no more pics! naturally i*ll pay for your help//// if the solution will be found!

viktor m

Original Poster:

8 posts

143 months

Wednesday 21st November 2012
quotequote all
i am normal person and I really appreciate your help, so i think that any problems should arise in our cooperation!