Where are you mounting the swirl pot?

[barroom_spert]

With space under the rear clip being limited, where are you mounting the fuel injection parts, Swirl pot, EFI pump etc?

[tuxman]

have mounted my injection pump and tank on the front bulkhead. pump as low as possible tank as high as possible !! . simon

[pb3]

I hope you have some good insulation or bobbin type pump mounts. The Factory used to put the low pressure fuel pumps on the back like that but I believe they relocated them to the sides to reduce noise and vibration. I would think a fuel injection pump will be even worse. I am putting mine down low, mounted horizontally, but then I have the advantage of a bottom floor to parts of my engine bay.

[tuxman]

pump cost a small fortune and is silent running ....to be honest i don,t think you will hear it above a screeeming chevy V8 !!!!! simon

[GTRMikie]

tuxman said:

pump cost a small fortune and is silent running ....to be honest i don,t think you will hear it above a screeeming chevy V8 !!!!! simon

I have low pressure pumps, fixed to the bulkhead, ticking away and a Holley injection pump hissing away but I can't here them when the engine is running!