Updates Available for Ultima Schematic

[USCANAM]

This message is for Ultima owners who have purchased our Ultima Wiring Schematic. We've clarified a few areas, and made some minor corrections. We'll snail mail the updates to you if you contact me at [e-mail]
No charge.
Due to the format the schematic was created in, the updates cannot be emailed.
Regards
Jack



>> Edited by USCANAM on Wednesday 2nd November 12:46

[builder]

Jack,

The email address listed here bounced. I will PM you my address...

Thanks,
-- Scott

[USCANAM]

builder said:

Jack, The email address listed here bounced. I will PM you my address... Thanks, -- Scott

Thanks Scott
Have made the correction
Jack

[stig]

Jack - how much is the schematic?

Not that my loom bears much resemblence to it anymore!

[USCANAM]

stig said:

Jack - how much is the schematic? Not that my loom bears much resemblence to it anymore!

Chris
The cost is $100 which includes shipping. The schematic is made as my CanAm is wired, although the appendix includes all the loom as supplied from the factory.
Even though I created the schematic, it was invaluable tracing down a wire that had shorted out a while back. Just knowing the basic routing of the circuits let me pin-point the faulty wire to the exact location.
Jack