Sparco Formula / Peltor G90M Hans Posts
Discussion
They are basically the same helmet shell, although the Peltor has built in earphones.
Want to retrofit Hans Posts: Could someone please post some pics of the posts in position from the back?; better still, the actual dimensions i.e. centre to centre of the posts across the helmet across the rear centreline and centre of post up from and including the bottom black trim. Ideally the Peltor, but as there are more around, the Sparco will do.
Thanks
Want to retrofit Hans Posts: Could someone please post some pics of the posts in position from the back?; better still, the actual dimensions i.e. centre to centre of the posts across the helmet across the rear centreline and centre of post up from and including the bottom black trim. Ideally the Peltor, but as there are more around, the Sparco will do.
Thanks
Trev
See this link http://www.stand21.fr/hans/Owner%20Manuel%20Hans1....
towards the bottom is the fitting instructions
Dave
See this link http://www.stand21.fr/hans/Owner%20Manuel%20Hans1....
towards the bottom is the fitting instructions
Dave
Dave
Can't use that because 1) mine's a Schroth and 2) given 'Manuel' it's obviously for the Spanish Market only
Seriously though, real handy, very clear and easy to understand and it shows lots of different helmets ........... I was just being a bit careful/cautionary because of the Peltor's ear-coms; one can just see a circular cutaway either side on the factory applied black thingie stuck on the inside of the shell that looks to be the preset position where the posts should/would go; this OM will allow me to check out that this is indeed what they are.
Ta Very Much
Can't use that because 1) mine's a Schroth and 2) given 'Manuel' it's obviously for the Spanish Market only
Seriously though, real handy, very clear and easy to understand and it shows lots of different helmets ........... I was just being a bit careful/cautionary because of the Peltor's ear-coms; one can just see a circular cutaway either side on the factory applied black thingie stuck on the inside of the shell that looks to be the preset position where the posts should/would go; this OM will allow me to check out that this is indeed what they are.
Ta Very Much
Be very careful, usually HANS equipped helmets have extra material where the posts fit, and the only people who should fit the stickers are approved fitters who are authorised by the helmet manufacturers.
Stand 21 and GPR are known to be approved.
It should not pass scrutineering without the HANS FIA sticker applied.
do a search for Hans posts and have a look through the results
Stand 21 and GPR are known to be approved.
It should not pass scrutineering without the HANS FIA sticker applied.
do a search for Hans posts and have a look through the results
Gassing Station | UK Club Motorsport | Top of Page | What's New | My Stuff