280 285 x25.4mm
Discussion
Wilwood do cheaper options....but whether they have the correct bolt PCD to suit your bells is another matter.
What discs are you currently using ? Or are you building a new setup ?
Reyland and a few other places are machining some OEM discs to accept bells, so could do whatever size/PCD etc you need.
http://www.reyland.co.uk/discs/
What discs are you currently using ? Or are you building a new setup ?
Reyland and a few other places are machining some OEM discs to accept bells, so could do whatever size/PCD etc you need.
http://www.reyland.co.uk/discs/
turbotoaster said:
lotus elise are 282mm and 25.4mm thick, you could machine them for ali bells
i used saab 308mm pagid discs as they are 25.4mm and again machined the centres for ali bells
Hii used saab 308mm pagid discs as they are 25.4mm and again machined the centres for ali bells
Thanks, I'm needing a height/total offset 47-50mm.
When you say machined the centres, what exactly do you mean? Just taking a standard disc(saab) and re drilling etc?
stevieturbo said:
Wilwood do cheaper options....but whether they have the correct bolt PCD to suit your bells is another matter.
What discs are you currently using ? Or are you building a new setup ?
Reyland and a few other places are machining some OEM discs to accept bells, so could do whatever size/PCD etc you need.
http://www.reyland.co.uk/discs/
Its a new setup, based around ap cp5040 calipers, to fit under a 14inch wheel. What discs are you currently using ? Or are you building a new setup ?
Reyland and a few other places are machining some OEM discs to accept bells, so could do whatever size/PCD etc you need.
http://www.reyland.co.uk/discs/
jason61c said:
Hi
Thanks, I'm needing a height/total offset 47-50mm.
When you say machined the centres, what exactly do you mean? Just taking a standard disc(saab) and re drilling etc?
taking a standard disc and machining all of the centre away then use an aluminum bell to bolt to them, basically same as what steve mentioned about what reyland doThanks, I'm needing a height/total offset 47-50mm.
When you say machined the centres, what exactly do you mean? Just taking a standard disc(saab) and re drilling etc?
Gassing Station | UK Club Motorsport | Top of Page | What's New | My Stuff