Stop watch second hand - 2s off centre - Traser H3

[dave_s13]

I've got one of these



Not the titanium version but same in every other way.

The second hand on the stop watch no longer sits bang on 12 O'clock, it actually sits 2 seconds back. Similarly the stop watch minute hand is very slighty off top dead centre too.l

Anyone advise as to the best DIY method for removing the rear case and, can you just manually push the hands back round a bit or will I bust it?

[Dominic H]

Yes, there is normally a sequence activated by pulling the crown out to the 1st postion and pressing the upper or lower chrono button. Pull out all the way to adjust the remaining register.

Hope this helps...

[dave_s13]

no such luck. Thanks anyway tho.

[Dominic H]

Give Traser a call/e-mail, there should be a sequence to reset.

[dave_s13]

Cheers, email sent, see what happens.

[Pesty]

1: pull out the crown to position 3 all 3 chrono hands are in their correct crono possition

2: keep push buttons a and b depressed simultaniously for at least 2 seconds ( the center stop second rotates by 360 corrective mode is activated)

a= top pusher b= botom pusher

adjusting center stop press a 1 short 1 long

press b

adjusting 1/10 second press a 1 short a 1 long

press b

to do minute counter minute counter in same way press a

then push crown back in to finish

hope that makes sense cos it means f all to me.

Edited by Pesty on Thursday 24th July 21:55

Edited by Pesty on Thursday 24th July 21:57

[Pesty]

could have saved myself some time writing all that out of teh manual. there is a bloody link on the instrucions

http://www.ronda.ch/pdf/ba5040.Be.pdf

[dave_s13]

top man worked a treat that!

A fine example of the ph collective minds' ability to solve the most trivial problems!