Advice needed on Temp Sensor for Edelbrock heads
Discussion
Hi Guys
I was wondering if anyone could help
I have just replaced my stock chevy L98 cast iron heads with Edelbrock Aluminium E-street items(in Overfinch Discovery).
The original water temp sensor in the cast heads is way too small to fit into the threaded holes in the e-streets
There is no mention of this anywhere in the literature or on Edelbrock's website.
I have also fitted a performer cam and inlet with a 600 carb - the TPinjection has been binned.
I know I could tap the original item into the water run in the inlet manifold, but if anyone knows of a better solution I would be grateful.
Many thanks
victor
I was wondering if anyone could help
I have just replaced my stock chevy L98 cast iron heads with Edelbrock Aluminium E-street items(in Overfinch Discovery).
The original water temp sensor in the cast heads is way too small to fit into the threaded holes in the e-streets
There is no mention of this anywhere in the literature or on Edelbrock's website.
I have also fitted a performer cam and inlet with a 600 carb - the TPinjection has been binned.
I know I could tap the original item into the water run in the inlet manifold, but if anyone knows of a better solution I would be grateful.
Many thanks
victor
You just need a male-to-female threaded adapter. Try Think Auto...
http://www.thinkauto.com/acatalog/On_line_shop_mal...
IMO, you're better-off with the water temp sender in the head.
http://www.thinkauto.com/acatalog/On_line_shop_mal...
IMO, you're better-off with the water temp sender in the head.
Gassing Station | Yank Motors | Top of Page | What's New | My Stuff