water pump gasket do i need it or not?
Discussion
fitted genuine water pump from mx5 parts and it leaked after 18 months ,(may have been my fault though as the alternater belt had been over tight and could have stressed the pump bearings causing leak?)
fitted one of their non-gen cheaper ones with gasket and it has been fine for two and half years now .think non-gen have plastic impeller aswell that dosn't corode like the tin ones on the genuine pumps
fitted one of their non-gen cheaper ones with gasket and it has been fine for two and half years now .think non-gen have plastic impeller aswell that dosn't corode like the tin ones on the genuine pumps
OnlyMX5ives said:
I bought a genuine one last time around and found the casting was appauling quality.
The 'pattern' ones visually look at least as good - and usually come with the gaskets.
just fitted a genuine mazda one, and the outer casting did look a bit crap, the machined mating surface was almost mirror like though, so i wasn't too concerned. according to mx5parts since they're machined to tighter tolerences they don't need a pre cut gasket as suchThe 'pattern' ones visually look at least as good - and usually come with the gaskets.
dg45 said:
fitted genuine water pump from mx5 parts and it leaked after 18 months ,(may have been my fault though as the alternater belt had been over tight and could have stressed the pump bearings causing leak?)
fitted one of their non-gen cheaper ones with gasket and it has been fine for two and half years now .think non-gen have plastic impeller aswell that dosn't corode like the tin ones on the genuine pumps
hmm.. hopefully that is the case! that or not enough / incorrect gasket sealant. i was under the impression fiat/lancia/VAG etc. always had problems with plastic impeller pumps - they used to fracture and fall apart from heat cycling presumablyfitted one of their non-gen cheaper ones with gasket and it has been fine for two and half years now .think non-gen have plastic impeller aswell that dosn't corode like the tin ones on the genuine pumps
i'd stick with metal, unless you put water in your cooling system?>!
Edited by dylan0451 on Wednesday 15th July 23:48
Gassing Station | Mazda MX5/Roadster/Miata | Top of Page | What's New | My Stuff