New owner, lots of Q's to come
Discussion
Just saying hi to start with.
Just taken delivery of my new tinker toy, MX5 Mk1 115bhp, free of charge from my sister-in-law.
It has a few issues, major one is no power, but free rev'ing above 1500rpm. But I already have a few things I can check, test and replace.
If I can get it going, then the question is, do I repair and restore, or do I kit it and change it into a MEV kit car?
Thats it for now.
V.
Just taken delivery of my new tinker toy, MX5 Mk1 115bhp, free of charge from my sister-in-law.
It has a few issues, major one is no power, but free rev'ing above 1500rpm. But I already have a few things I can check, test and replace.
If I can get it going, then the question is, do I repair and restore, or do I kit it and change it into a MEV kit car?
Thats it for now.
V.
Perhaps check that the timing is correct - I accidentally moved the CAS on my old 1.6 to completely the wrong position and although it seemed to run and drive normally, it had almost no power from about 3000 upwards. IIRC I had set it to something like 2 or 4 degrees BTDC rather than 12 to 14.
TBH although the above is good advice I'd be looking at replacing plugs (properly gapped), leads and air filter as the cheapest cost options before heading in other directions.
The coil packs have been known to break down under load and also the CPS can play up but second-hand ones are available relatively cheaply.
HTH.
Cheers, Pewe.
The coil packs have been known to break down under load and also the CPS can play up but second-hand ones are available relatively cheaply.
HTH.
Cheers, Pewe.
Gassing Station | Mazda MX5/Roadster/Miata | Top of Page | What's New | My Stuff