Discussion
Yup.
Done some internet searching and it all points to the screws which hold down the wiper mouldings letting water by, seems common(ish).
So need to get the scuttle panel off and replace the washers which must have just perished over time - apparently not too bad a job, just time consuming.
Giving her a full service this weekend, so probably next weekend's job tbh.
Done some internet searching and it all points to the screws which hold down the wiper mouldings letting water by, seems common(ish).
So need to get the scuttle panel off and replace the washers which must have just perished over time - apparently not too bad a job, just time consuming.
Giving her a full service this weekend, so probably next weekend's job tbh.
When you take the scuttle panel off use the finest pick you can get or a very fine bladed screw driver to gently remove the screw caps. I've replaced no end of screens in MX5's that some rough bd has just rammed whatever they had into them to remove them, it chews them up and they look horrible afterwards.
Gassing Station | Mazda MX5/Roadster/Miata | Top of Page | What's New | My Stuff