Changing drop-link and anti-roll bar bushes (NA 1.8)
Discussion
After extensive internet searches, I've been unable to find a good video or picture guide to changing the front ARB bushes and drop-link bushes on a mk1 (NA) eunos 1.8 1996.
Can anyone help? We have the replacement bushes from MX-5 parts, and will be using a g-clamp and washers as a makeshift bush press. thanks
Can anyone help? We have the replacement bushes from MX-5 parts, and will be using a g-clamp and washers as a makeshift bush press. thanks
Take a look here: Mazdamenders.net
If you don't find what you need, post the question on there and you'll quickly get an answer
If you don't find what you need, post the question on there and you'll quickly get an answer
HughS47 said:
After extensive internet searches, I've been unable to find a good video or picture guide to changing the front ARB bushes and drop-link bushes on a mk1 (NA) eunos 1.8 1996.
Can anyone help? We have the replacement bushes from MX-5 parts, and will be using a g-clamp and washers as a makeshift bush press. thanks
They are dead east to do.Can anyone help? We have the replacement bushes from MX-5 parts, and will be using a g-clamp and washers as a makeshift bush press. thanks
Undo the drop links first then the 4 bolts holding the ARB to the body and 1 at either end if the ARB
Take the whole lot out from under the car.
I removed my old bushes by burning them out with a hot air gun.
Then pressed the new ones in with my vice.
Didn't take much pressure.
Hope this helps.
Gassing Station | Mazda MX5/Roadster/Miata | Top of Page | What's New | My Stuff