E46 325ti Track Car

[JNIOW]

Hi all, I'm building a track day car from an E46 325ti. Does any one here track one, and what camber / toe settings do you use. It's most definitely not a daily driver but I will need to drive to the circuits so a little compromise is necessary. It has BC BR coilovers with adjustable camber plates if that helps. TIA

[MrC986]

I have a share in a 325ti that we use for track although the suspension was replaced by a BMW specialist (HRD Racing) with fully adjustable coil overs & set up by them though a printout of the various settings wasn’t necessary. Have you put either a front strut brace or strut tower reinforcement plates on yet? - it’s one of the things I’m thinking of doing.

You might want to ask the same question on the M3cutters forum.

[motorhole]

BMW car club racing cup class run these. Lots of potential information and experience to tap into - not sure if there is an online group/forum/community to join. Although the class is quite heavily regulated so all cars run the same suspension, brakes etc.

[JNIOW]

MrC986 said:

I have a share in a 325ti that we use for track although the suspension was replaced by a BMW specialist (HRD Racing) with fully adjustable coil overs & set up by them though a printout of the various settings wasn’t necessary. Have you put either a front strut brace or strut tower reinforcement plates on yet? - it’s one of the things I’m thinking of doing.

You might want to ask the same question on the M3cutters forum.

Have front and rear strut braces already, cage is going in too. Posted on cutters some time ago, but it's very "M3" centric. I have one of those too so not an issue 😉