S2000 seat measurements

[TVR Tommy]

Could someone please measure how far apart the seat runners bolts are at the front, And is the rear of the runners bolted to the floor. If so how far is the rear bolt from the front bolt. Could I also get a measurement from the widest point at the base.

Thanks

[TommyBuoy]

I'll take a crack at this -

Bearing in mind my measurements where taking on a measure with the seat in situe, the front bolts are 440mm apart, with 425mm to the rear bolt on the outside rail, 475mm to the rear bolt for the inner.

Overall widt, outside to outside of the rail is 475mm.

The only way to get an accurate measure would be for someone who has removed their seat...I haven't and not going to as I don't have a touque wrench...

[TVR Tommy]

Thanks for those measurement. They don't need to accurate. Could be a bit of a problem with the bolts on the side at the rear. As the car the seats would be going in are bolted to the floor front and rear.

[TommyBuoy]

I'm not sure if I have misunderstood you, but the bolts are into the floor front and rear, I was referencing the fact the the two rails are of different length in relation to the centre console etc.

Again, I may have misunderstood you comment above!