Garmin Edge 1030 - issues
Discussion
Morning all,
Not sure what's happened here, with moving house I'd not been out on the bike in a while, turned my Garmin on and there was a firmware update which took a few times to verify but everything seemed to work OK.
With the move I had to create a few new routes from the house so did the usual on one of the websites, created a route, downloaded the GPX and imported to the Garmin. The snag is when I load the route I get the line for the road, but that's pretty much it, there's no mapping displayed just a line and the turns. So I could be going down a road and previously I would see the map displayed and see I needed to take the 3rd turn on the left, now I just have a line with a left hand kink, so I'm unable to tell if it's the 1st, 2nd or 3rd turn if that makes sense?
If I don't load a route and just ride I see the full map?
Not sure what's happened here, with moving house I'd not been out on the bike in a while, turned my Garmin on and there was a firmware update which took a few times to verify but everything seemed to work OK.
With the move I had to create a few new routes from the house so did the usual on one of the websites, created a route, downloaded the GPX and imported to the Garmin. The snag is when I load the route I get the line for the road, but that's pretty much it, there's no mapping displayed just a line and the turns. So I could be going down a road and previously I would see the map displayed and see I needed to take the 3rd turn on the left, now I just have a line with a left hand kink, so I'm unable to tell if it's the 1st, 2nd or 3rd turn if that makes sense?
If I don't load a route and just ride I see the full map?
Gassing Station | Pedal Powered | Top of Page | What's New | My Stuff