Can't get new tyre onto rim
Discussion
The tyre in question is a 12" to go on a plastic rim. I've got it onto one side of the rim, popped the tube in and got it about half over the other rim. Have bent two tyre levers, tried using a washing up liquid solution, and looked at the screwdrivers!
What are the other hints and tips I need???
What are the other hints and tips I need???
I've had to replace far too many tubes in the 12" plastic wheels on our three wheeled buggy.
Getting the bead of the tyre right down into the profile of the rim helps a lot. In the end I'd done so many I could do them without levers.
The kids are well out of buggies now, and the blasted thing went to the tip....yay
Getting the bead of the tyre right down into the profile of the rim helps a lot. In the end I'd done so many I could do them without levers.
The kids are well out of buggies now, and the blasted thing went to the tip....yay

Disco You said:
Push the bead of the tyre into the middle of the rim.
This is the only answer.Phil & Teds by any chance?
I have to warn you that once they start to puncture they make a habit of it and the tyre is bespoke IIRC.
I was so fed up with the pain of changing tubes I sold the pram.
Very annoying.
Gassing Station | Pedal Powered | Top of Page | What's New | My Stuff


