Stans No Tubes MTB Tyres
Stans No Tubes MTB Tyres
Author
Discussion

edcs

Original Poster:

1,449 posts

199 months

Tuesday 27th May 2014
quotequote all
I've just bought a set of wheels with Stan's Crest rims with the intention of running them tubeless. I was under the impression that you could run any MTB tyre tubeless with this system - I was just wondering if I was right?

I ran tubeless on my road bike for about a year so have a little bit of experience with it all, but I was under the impression that you had to run specific tubeless tyres due to the higher pressures involved.

Mr Gearchange

5,892 posts

235 months

Tuesday 27th May 2014
quotequote all
You'll be able to run any tubeless tyre on it

phil-sti

2,976 posts

208 months

Tuesday 27th May 2014
quotequote all
Any tubeless tyre, you just need removable valves, rim tape and sealant

paddy27

1,745 posts

263 months

Tuesday 27th May 2014
quotequote all
I believe you can make any mtb run tubeless. Apparently works much better if you use tubeless ready tyres.
Just gone tubeless on my Norco. Used some specialised purgertory tyres.
With proper tyres should be less or no air 'burps'.

gp1699

406 posts

233 months

Tuesday 27th May 2014
quotequote all
My bike came with Stans crest rims and Maxxis Ardent EXO rubber...

So i changed the valves and used a couple of scoops of Stans sealant.

All good, worth doing IMO.

gp1699

406 posts

233 months

Tuesday 27th May 2014
quotequote all
also you can run them at lower pressures as you wont get snake bites smile

edcs

Original Poster:

1,449 posts

199 months

Tuesday 27th May 2014
quotequote all
Sounds like it's worth trying then, I've got loads of sealant left from the road bike so will give it a go. I've currently got WTB Moto 2.3's, but I need to replace the rear tyre as it's got a tear right on the bead. Guess I could get a tubeless ready replacement and experiment with the front - worst comes to the worst I have to stick a tube in the front.

Mr Gearchange

5,892 posts

235 months

Tuesday 27th May 2014
quotequote all
gp1699 said:
also you can run them at lower pressures as you wont get snake bites smile
This - very handy on rocky trails as you get far better grip.

However, be aware that lower pressure gives you much better cornering force, and you can burp the air out of the tyre


paddy27

1,745 posts

263 months

Tuesday 27th May 2014
quotequote all
gp1699 said:
also you can run them at lower pressures as you wont get snake bites smile
This the reason I have gone tubeless. Loads of rocks in the peaks. Kept getting pinch flats!

edcs

Original Poster:

1,449 posts

199 months

Tuesday 27th May 2014
quotequote all
Sounds good - looking forward to getting my MTB back up and running again. I knackered the rear wheel ages ago and have been on the road bike since.

Ordered a UST Maxxis High Roller to replace the torn tyre. Forgot how expensive MTB tyres are!