Tubeless Left for 12 Mnths - What Can I Expect?
Tubeless Left for 12 Mnths - What Can I Expect?
Author
Discussion

bikemonster

Original Poster:

1,188 posts

270 months

Monday 30th April 2012
quotequote all
Hello my imaginary friends.

For reasons to dull to explain, my MTB has been in storage for 12 months, with Slime in the tyres. I'm expecting most of the air to have escaped from the (tubeless) tyres.

Beyond that, any predictions of what I will find?

Tyres ready to be thrown away with a solid lump of goo attached to each?

Chunks of solidified slime which I can remove and replace?

Something else entirely?

Just one more question?

cjs

11,653 posts

280 months

Monday 30th April 2012
quotequote all
When you say slime, do you mean Stans or similar? If so just remove the tyre, wash/peel off all the old crud and refit and fill with new.

bikemonster

Original Poster:

1,188 posts

270 months

Monday 30th April 2012
quotequote all
That's the stuff.

Very encouraging. I'll get my bike back in 6 weeks or so. And when I do I'll report back.

jshell

12,056 posts

234 months

Tuesday 1st May 2012
quotequote all
Had tyre-milk (latex) sealent in my HR's and they sat around for ages. Took the tyres off and just peeled the sealant out from the tyre and used a rough cloth to clean the wheels. Nae probs!

bikemonster

Original Poster:

1,188 posts

270 months

Wednesday 2nd May 2012
quotequote all
jshell said:
Had tyre-milk (latex) sealent in my HR's and they sat around for ages. Took the tyres off and just peeled the sealant out from the tyre and used a rough cloth to clean the wheels. Nae probs!
Thanks guys.

Now I'm just like a kid bouncing from foot to foot with the excitement of getting my bike(s) back. smile

Lots more sleeps! frown

bikemonster

Original Poster:

1,188 posts

270 months

Friday 13th July 2012
quotequote all
Just bumping with the Acshil Result.

The front tyre still had plenty of very liquid sealant. Added air, spun the wheel, some hissing which grew fainter and then disappeared.

The rear wasn't holding pressure very well. I pushed the bead off the rim, poured some sealant in and added air. It took some pumping with a floor pump, but after a few minutes all sealed up nicely.

All good!