90 Se Oil Leak

[90 SE TL]

I replaced the timming belt , water pump and aux pulley shaft seal, and the car runs good but after a test drive i came back and there was a oil leak, oil was misted on the firewall and all over the timming belt. I did notice that I had the one way valve on the air oil seperator backwards so I thought that may of caused to much internal presure and the oil was being forced out one of the seals. I corrected the valve but still am getting the oil leak, the only thing i can think of now is they may of send me the wrong aux shaft seal or something, any one else had this problem
thanks
CAL

[sanj]

I'm fairly certain those seals are directional. If you look carefully at the face of the seal you should see a small arrow indicating the direction of shaft rotation. I have heard of at leat one case where camhaft seals were provided that were intended for the opposite direction. Caused quite a leak, IIRC.

[lotusse89]

The pulley shafts also require a sealant inside the end with the bolt. Otherwise oil can get out there.