peugeot 306 heater matrix.
Discussion
Doesn't sound good and not an easy job, more info on the link below
http://www.306gti6.com/forum/showthread.php?id=789...
hope it doesn't scare you too much.
http://www.306gti6.com/forum/showthread.php?id=789...
hope it doesn't scare you too much.
Nothing particularly difficult (i.e. most nuts come off easily enough), but there's just LOTS of bits to remove. Did mine last year and now it needs doing again. Grr. Search the GTI6 site as there's a few people who offer to do it for not a ridiculous amount of money.
Not necessary to change the pipes in the bulkhead though - leave the current ones in and separate the matrix from it - I spent ages getting the engine bay side pipes off and ended up snapping the fittings (they're expensive pipes from Pug). It's also difficult to pull the pipes through the bulkhead grommet (and get back in).
Not necessary to change the pipes in the bulkhead though - leave the current ones in and separate the matrix from it - I spent ages getting the engine bay side pipes off and ended up snapping the fittings (they're expensive pipes from Pug). It's also difficult to pull the pipes through the bulkhead grommet (and get back in).
Gassing Station | French Bred | Top of Page | What's New | My Stuff