Clear acrylic adhesive for display case

[Roman]

I am looking to make from scratch a display case from 4mm thick clear acrylic sheet.

The supplier has kindly offered to cut the sheet to size for me (by band saw so I will need to wet n dry edges) but I wondered if anyone knew what adhesive I should use to create an 'invisible' (or as close as I can get) join?

[Red Firecracker]

I think you're always going to see an edge unless you use a single piece of acrylic and then heat and mould it using male and female wooden moulds.

A solvent joint is going to look like this;



The alternative is to use a lead tape over the edges as per this;

[Skodaku]

Suggest you try "Glue n'Glaze" by Deluxe Materials. It's probably the best adhesive for attaching model aircraft canopies etc etc, dries clear and bonds "most" plastics. It's a PVA type material so excess can be removed with a damp cloth. Your local model shop should stock it or look at link below. It's made in Hampshire, (despite the slightly cheesy name).

www.deluxematerials.com

[Roman]

Thanks guys.

[Eric Mc]

Gator Glue is something similar. It's American but can be bought at Modelzome outlets.

[jas xjr]

is there anything you do not know about eric?