Tamyia 1/48 Spitfire Mk1
Discussion
MBBlat said:
No Issues when following the instructions, I forgot to put the compass in its PE housing until after the control column was in, mad fitting a bit tricky.
Got the fuselage halves together, only a little filler & sanding required. Rear tailplane is almost snap fit.
Superb. Makes it so much easier to get a good result when a kit is both well detailed and well engineered.Got the fuselage halves together, only a little filler & sanding required. Rear tailplane is almost snap fit.
Decals and weathering done, just need the final matt coat, add the side door and properly attach the canopy and aerial mast and its done
Tamiya 1/48 Spitfire Mk1 by MBBlat, on Flickr
Tamiya 1/48 Spitfire Mk1 by MBBlat, on Flickr
Tamiya 1/48 Spitfire Mk1 by MBBlat, on Flickr
I've also subsequently taken away the chipping on the prop as I've been told spit props don't wear like this
Tamiya 1/48 Spitfire Mk1 by MBBlat, on Flickr
Tamiya 1/48 Spitfire Mk1 by MBBlat, on Flickr
Tamiya 1/48 Spitfire Mk1 by MBBlat, on Flickr
Tamiya 1/48 Spitfire Mk1 by MBBlat, on Flickr
I've also subsequently taken away the chipping on the prop as I've been told spit props don't wear like this
Tamiya 1/48 Spitfire Mk1 by MBBlat, on Flickr
Gassing Station | Scale Models | Top of Page | What's New | My Stuff