How big is the Cerbera engine bay

[Spunagain]

Hi All

Can anyone who has measured the Cerbera engine bay dimensions post them? I tried a seach with no hits I have vague thoughts of a conversion and think about what would fit in there.

Thanks in advance!


Regards

Spunagain

[Big Al.]

Might be better to ask over in the Cerbie forum, if you want me to move this just shout.

[Omerta]

What are you thinking of dropping in? You're likely to find you're limited more by the chassis rails than the fibreglass, although it is also tight for routing exhaust back and down in the standard configuration.

I have some detailed chassis rail measurements somewhere - PM me and if I can find them I'll send them to you.

[Spunagain]

Cheers Omerra

PM sent!

Regards
Spunagain

[Spunagain]

Hi Again

Thanks to Omerta who has given me some measurements, what I am missing is the distance from the bottom chassis tail to the bonnet, has any one got some measurements for this at the front and back of the engine bay?

Thanks

Regards
Spunagain

[ridds]

Just measured mine 680mm to the top of the sump shield.

Not hugely accurate but gives you an idea. Similar both front and rear.

[Boosted LS1]

Crank centreline measurement may be useful if you don't want to upset the drivetrain. Room for a hemi?

Edited by Boosted LS1 on Saturday 7th February 00:07