value of a speed six engine going down?
Discussion
I guess it depends!! If the rattle meant it has popped a shim the block could be fubar'd, crank could need regrind, complete bearing set, rods could have picked up and need honing, will need new little bearings anyway, new set of rings, pistons may be ok i guess
Then top end, valves, valve seats, stems seals, head gasket, cams, followers etc etc etc!
The cost of rebuilding could be the same as a new engine from say TVR Power...so it may not be that cheap really!
Then top end, valves, valve seats, stems seals, head gasket, cams, followers etc etc etc!
The cost of rebuilding could be the same as a new engine from say TVR Power...so it may not be that cheap really!
Hello Group.. first post.
Am I alone in seeing, and bidding on,supposedly, one of the original engines from the 2003 Le Mans Tuscans recently posted on Ebay ?
Complete with injection and ancillaries, unfortunately the seller pulled the listing early.
I may be wrong but I think the engine was located in the Leicester area .. as was the one discussed above.
Am I alone in seeing, and bidding on,supposedly, one of the original engines from the 2003 Le Mans Tuscans recently posted on Ebay ?
Complete with injection and ancillaries, unfortunately the seller pulled the listing early.
I may be wrong but I think the engine was located in the Leicester area .. as was the one discussed above.
Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff