diagnostic cable connection
Discussion
Is there only 1 diagnostic cable configuration for the S6 engine that uses the 3 pin connector? I just got mine today (raceproved one) and when connected to the car/laptop (via the serial port) it says 'ECU not connected' I am going to try a serial to USB adaptor tomorrow but is there anything else I am missing? I am running the software on an XP configured laptop from a desktop folder by running the exe.file. the program appears to start as it should but it dose not 'see' the connection to the car.
Shep
T350 Al said:
You have to make sure the port is assigned as COM1 for the software to see it. Should be able to change it from Control Panel>Devices
Thanks Al, should have asked earlier, its too dark to go and have a play now! Does it need a driver installing to make it run as well?Shep
PetrolHeadPete said:
Just reconnected mine after a little while and brain had faded...ignition on, engine not running but forgot to push the key for immobiliser and wondered why it would not connect...doh...immobiliser must be disarmed...one to remember
What a nobber I am.... that will be why mine didn't work on the serial cable!! wasted £5 on a serial port converterShep
Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff