harmonic puller problem
Discussion
Hi james,
I used a puller from Machinemart which cost less than £10 and it worked fine.
They are pigs and can be on very tight.
It will take some force but will come. I used my own centre bit as the bolt on mine would have gone inside the crank shaft bolt hole and damaged the threads.
Good luck,
Richard.
I used a puller from Machinemart which cost less than £10 and it worked fine.
They are pigs and can be on very tight.
It will take some force but will come. I used my own centre bit as the bolt on mine would have gone inside the crank shaft bolt hole and damaged the threads.
Good luck,
Richard.
I had the same problem, broke 3 cheap pulley removers, ie machine mart etc
had to use a hydraulic puller in the end, and lots of heat, ended up destroying the balancer.
try tapping the puller with a hammer when its under load,
i think its luck of the draw, some seem to come off ok and some are pretty much welded on.
good luck
had to use a hydraulic puller in the end, and lots of heat, ended up destroying the balancer.
try tapping the puller with a hammer when its under load,
i think its luck of the draw, some seem to come off ok and some are pretty much welded on.
good luck
Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff