Speed Six Dipstick Woe
Discussion
My stick fell off?
It's been getting a bit waggly for the last year or so, I just thought that's the way it is, as you do. Until, last week, I was checking my level and it seemed more waggly than usual, like the moment just before Uri Geller's spoon falls apart. "I better be careful with that" I told myself and gingerly replaced it in the tube.
Sod's law takes over and I accidentally let it drop the last few inches and lift the lid to find the stick has dropped off and into the tube. No problem, it's reachable, so I fish it out and rather than it being flared through a hole, it's got a teensy dollop of weld which is no longer holding it in place.
Looking at the underside of the screwcap, there's a rubber seal holding the plate with the hole, I'm wondering if the plate is easily removed or will it mangle the rubber
Now, I'm not a moaner, I'd just like to ask the panel if this has happened to anyone else and if so, what did you do about it?
Obviously there are two courses of action: Repair or replace. The tightwad in me fully expects the sharp intake of breath "Phwoar, a dipstick? That'll cost you sir" from my nearest 'pusher'. So, I'm thinking I could get some local Johnny with aluminium welding facility to gob it back on as long as I can persuade the flange away from the rubber.
What do you think?
I know, it's a heck of a waffle about nothing at all, but it's Friday and the alternative is I can go and put some doors on the kitchen units or grout a tile.
Pete
It's been getting a bit waggly for the last year or so, I just thought that's the way it is, as you do. Until, last week, I was checking my level and it seemed more waggly than usual, like the moment just before Uri Geller's spoon falls apart. "I better be careful with that" I told myself and gingerly replaced it in the tube.
Sod's law takes over and I accidentally let it drop the last few inches and lift the lid to find the stick has dropped off and into the tube. No problem, it's reachable, so I fish it out and rather than it being flared through a hole, it's got a teensy dollop of weld which is no longer holding it in place.
Looking at the underside of the screwcap, there's a rubber seal holding the plate with the hole, I'm wondering if the plate is easily removed or will it mangle the rubber
Now, I'm not a moaner, I'd just like to ask the panel if this has happened to anyone else and if so, what did you do about it?
Obviously there are two courses of action: Repair or replace. The tightwad in me fully expects the sharp intake of breath "Phwoar, a dipstick? That'll cost you sir" from my nearest 'pusher'. So, I'm thinking I could get some local Johnny with aluminium welding facility to gob it back on as long as I can persuade the flange away from the rubber.
What do you think?
I know, it's a heck of a waffle about nothing at all, but it's Friday and the alternative is I can go and put some doors on the kitchen units or grout a tile.
Pete
Edited by S1X OK on Friday 11th August 21:25
billynomates said:
gandalf said:
billynomates said:
gandalf said:
Quiet weekend is it?
Nope of to Silverstone tomorrow...just need to check the dip stick.
Bit keen I thought it was Sunday?
True..lets see how it works out...you going?
PS Sorry for hijacking the thread Hope the dipstick problem is an easy fix.
Nope got no tickets and have caught the dog sitting rota this weekend
Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff