Is my engine knackered?
Discussion
Hi!
I bought a speed 6 cerebra yesterday and drive it about 200 miles home
Drove perfectly right up to the last 60 or so miles when it started to sound very rattly at the top end (like an old Ford needing the valve clearances doing).
I pulled over, topped up and it seemed to quieten down. Started this morning, topped up oil correctly and sadly there’s a top end rattle again and low oil pressure (19psi) once warm.
It has a lump of service history, has had a rebuild back in 2011 and still drives fine. I’m wondering if it is a symptom of clearances (not been done for 4 years / 3000 miles ago) or more likely something worse…?
I’m based in South Wales so any help would be really appreciated.
I bought a speed 6 cerebra yesterday and drive it about 200 miles home
Drove perfectly right up to the last 60 or so miles when it started to sound very rattly at the top end (like an old Ford needing the valve clearances doing).
I pulled over, topped up and it seemed to quieten down. Started this morning, topped up oil correctly and sadly there’s a top end rattle again and low oil pressure (19psi) once warm.
It has a lump of service history, has had a rebuild back in 2011 and still drives fine. I’m wondering if it is a symptom of clearances (not been done for 4 years / 3000 miles ago) or more likely something worse…?
I’m based in South Wales so any help would be really appreciated.
mrpenks said:
robsco said:
Is that low oil pressure when warm at idle or on the move?
Just when idle. I’m concerned I may have had a combination of oil to thin, and not enough of it…!Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff