Cerbera Sp6 Decat
Discussion
I ran my car for 18months without a de cat chip and it was fine,no problems. A number of garages told me it wasn't necessary when my Cerb was in for a service or some upgrade.
When it was at TVR Power for it's 1000mile service after my rebuild Dom said he would put a chip in for me, I don't know if he did but if he did I genuinly haven't noticed any difference.
When it was at TVR Power for it's 1000mile service after my rebuild Dom said he would put a chip in for me, I don't know if he did but if he did I genuinly haven't noticed any difference.
Willie at Meerkat made me two stunning silenced de-cats for my cerb much cheaper than off the shelf units and every bit as good if not better ( Good enough for the late Colin Mcrae good enough for me) . He will fabricate exactly what you want.
If you do use him tell him it was me that put you on to him i have just this week had my Mini's exhaust done by him as well see half way down the page for his work.
He did my full Cerbs System you are welcome for a look and listen it is 100% better than the old system and not to over the top.
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
http://meercat-exhausts.com/
If you do use him tell him it was me that put you on to him i have just this week had my Mini's exhaust done by him as well see half way down the page for his work.
He did my full Cerbs System you are welcome for a look and listen it is 100% better than the old system and not to over the top.
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
http://meercat-exhausts.com/
Edited by scotty_d on Thursday 14th June 22:46
scotty_d said:
Willie at Meerkat made me two stunning silenced de-cats for my cerb much cheaper than off the shelf units and every bit as good if not better ( Good enough for the late Colin Mcrae good enough for me) . He will fabricate exactly what you want.
If you do use him tell him it was me that put you on to him i have just this week had my Mini's exhaust done by him as well see half way down the page for his work.
He did my full Cerbs System you are welcome for a look and listen it is 100% better than the old system and not to over the top.
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
http://meercat-exhausts.com/
Must be good Scott as I thought it sounded good as it was!If you do use him tell him it was me that put you on to him i have just this week had my Mini's exhaust done by him as well see half way down the page for his work.
He did my full Cerbs System you are welcome for a look and listen it is 100% better than the old system and not to over the top.
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
http://meercat-exhausts.com/
Edited by scotty_d on Thursday 14th June 22:46
I'll speak to them..
RPE11Y said:
Is it necessary to re-chip after decatting a Sp6 Cerbera?
Who has done this and what are your views on it?
No, you do not have to.Who has done this and what are your views on it?
A remap might make sense, but the lambdas measure before the catalytic converters,so are not affected by removing the cats.
You do increase flow a little though.
Björn.
natben said:
I ran my car for 18months without a de cat chip and it was fine,no problems. A number of garages told me it wasn't necessary when my Cerb was in for a service or some upgrade.
When it was at TVR Power for it's 1000mile service after my rebuild Dom said he would put a chip in for me, I don't know if he did but if he did I genuinly haven't noticed any difference.
Had Dom decat my sp6 while having engine rebuild, I went for the decat EPROM map and all I can say is the car is completely new... Ok before build 2 cylinders were out and it was behaving like a donkey but since work done. No need to blip throttle on start up, no need to keep warm after start incase of stall. Heat management seems much better!When it was at TVR Power for it's 1000mile service after my rebuild Dom said he would put a chip in for me, I don't know if he did but if he did I genuinly haven't noticed any difference.
Just can get these 1000 miles out the way quick enough is it me or does 3000RPM come up way too quickly?! But even at that range the pipes are singing. Right now though feels like any more rpm would blow up... Lol
LOVE it, I say map it for the extra bhp and torques anyway!
Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff