Thin washer for crank sensor, how thick?

[Peppe]

I am working on a SP6, when mounting the crank sensor it touches the flywheel. In the Sagaris manual it say that the sensor should be mounted with a thin washer. How thick should the thin washer be?

[clive f]

I would image the sensor should be 1-2mm clear of the flywheel, give jason a call at str8six he`ll be happy to tell you the exact washer thickness/sensor gap.

[-Jamie-]

There is actually a set tolerance for this, i can not remember it though!

[Peppe]

I asked Dom at TVR Power about the washer, he say it should be 1 mm thick, so that is what I am going to use.

[puckrup]

I have a BAD crank sensor fault on Sag, how easy is it to replace Crank Sensor? How much access do you need to do this?