dumb ass question that i should know the answer to!!
Discussion
RonnieH said:
Got a vintage car that won't start, was run on Xmas day, and ran fine, tried to start today, got fuel, battery, and spark at the points when I flick them, but nothing getting to plugs,coil duff???. .
Ta
Might be the coil, take the king lead and hold it by the block to see if you have a spark there?Ta
Usual routine for non starters must begin with: is there a spark? If there is then onto: is there fuel in the cylinders? If there is then: can you smell fuel from the exhaust? Usual suspects must be ignition and then fuel. Generally cars not starting when there has been no misfiring or wheezing from the engine have an ignition problem. Good Luck.
I'm gonna spend some time on it in the morning,would like to use it tomorrow, I doubt its anything too serious, after all, there's not much that can go wrong!!
Will start by cleaning points,then remove and earth plug to check for spark, then check fuel is getting through ok, whilst the battery is on charge just to make sure it has decent power. . .
Will let ya know how I get on!!
Will start by cleaning points,then remove and earth plug to check for spark, then check fuel is getting through ok, whilst the battery is on charge just to make sure it has decent power. . .
Will let ya know how I get on!!
You say you have a spark at the point if you flick them, but are they actually opening and closing when the engine is cranked over and is the gap OK? 15 thou should be a good bet IIRC.
What about the rotor arm contacts and also the centre contact on the cap, especially if its the strung type.
What about the rotor arm contacts and also the centre contact on the cap, especially if its the strung type.
So, first up its a 1929 Morris minor, with ohc engine as used in the early mg's. . .
Fiddled with a few things, points were opening, cleaned them anyway, rotor arm aswell, then checked power into coil from ignition, all good, then checked other side of coil whilst turning engine over, all good, but still no spark at plug, however, there's a screw in suppresor, and the lead had basically crumbled, so I cut 1/2 inch off the lead, screwed it back in, and success!! . .
Ta for all ideas!!
Now I'd better clean it before I go for a drive!;
Fiddled with a few things, points were opening, cleaned them anyway, rotor arm aswell, then checked power into coil from ignition, all good, then checked other side of coil whilst turning engine over, all good, but still no spark at plug, however, there's a screw in suppresor, and the lead had basically crumbled, so I cut 1/2 inch off the lead, screwed it back in, and success!! . .
Ta for all ideas!!
Now I'd better clean it before I go for a drive!;
Gassing Station | Classic Cars and Yesterday's Heroes | Top of Page | What's New | My Stuff


