Problem to arise with Plastic/Rubber inhouse parts

[glow worm]

I understand we (TVR owners) are likely to face future problems with a lot of in-house made trim parts. Multipart (via a manufacturer in Stoke..who has now gone out of business) were going to make them with TVRs dies and machine ( "Make your own parts" inc). Multipart were not prepared to place volume orders hence I doubt any stocks exist. I'm told the equipment has now been recovered (by TVR) and shipped with the rest of the containers...to the "unknown" destination.
So if there is any enthusiast mould maker out there, an opportunity exists...these bits are going to be as rare as hens teeth.... So please ....someone step up to the mark....or dollar... or hopefully pound... and start a little business.

[BliarOut]

Woolies trim stock all the standard rubber profiles off the shelf.