Anyone used Turner Engineering for RV8 work/bits?

[Pupp]

Positive comments here please, anything negative by PM.

Oh, for heads

[Derek Smith]

Turner engineering are a very professional outfit, a husband and wife team with a couple of other employees. Their standards of engineering are very high. Their flanged pistons are the class of the field with a clever little seal that limits the chances of further problems. If you don't necessarily want your old block used, they normally have a number of refurbished engines ready for swapping. Their prices are very reasonable. A lot of these other suppliers of RV8s use Turner as supplier, although that is a point in their favour.

So much for the good news.

The bad news is that they deal only in Land Rover/Range Rover RV8s. You'll have to put your own cams in and that. They do make a nice job of smoothing the airflow into the inlet valves.

[crackeddash]

Used them for my Range Rover engine and was very impressed with their quality. All the Land Rover boys say they are one of the best.
No hesitation in recommending them.