Cerbera vibration at rear between 70-75mph
Discussion
Cerbera vibration at rear at speed
Please could someone point me in the right direction for a fault i am having
with my cerbera 05 speed six, when i am on the motorway between 70-75mph
the car is vibrating slightly from the rear eg: under the seat i have had the wheel
alignment done new rear wheels and tyres but its still there. Any ideas?
Thanks
Ed
Please could someone point me in the right direction for a fault i am having
with my cerbera 05 speed six, when i am on the motorway between 70-75mph
the car is vibrating slightly from the rear eg: under the seat i have had the wheel
alignment done new rear wheels and tyres but its still there. Any ideas?
Thanks
Ed
I used to get this on another car when the tyre pressures weren't equal on both sides... Turned out one side had a slow puncture and was a few psi less than the opposite side.
Edit: Just read you have replaced wheels and tyres so its probably unlikely!
Edit: Just read you have replaced wheels and tyres so its probably unlikely!
Edited by thenick on Tuesday 29th April 19:08
A few things not sure how they apply to the cerb...but on the chim Ive had vibration a few times. Once it was because the UJ in the driveshaft hadnt been greased , once it had been dismantled , packed with grease and re-assembled vibration went away. Another time it was wheel balance - just because you've got new wheels and tyres doesnt mean they've balanced it properly. Last set of tyres I tried 3 different places before the high speed vibration at the rear was eliminated. Turns out one of the more famous tyre places that did the second balance had got it 25g out on one wheel !
532ed said:
Thanks Mark, the car has only 8000 miles on it which one do you think it maybe?
I have not had this problem on my TVR but I have had it on my Jeep.Without seeing your car it would be impossible to diagnose. The best thing you can do (if you can) is jack it up high enough (with something other than the jack as support) and wiggle the prop and drive shafts about. Also try spinning the wheels when you are under the car to see if there are any irregularities - this will be hard to spot though.
If you cant do that I would take it to a garage. Vibration is not a good thing and it means that something is not wearing like it should. It will also cause other parts of the car stress and to possibly work loose.
Gassing Station | General TVR Stuff & Gossip | Top of Page | What's New | My Stuff



