Sagaris Fuel Lines

[Dave85chim]

Morning all,

I need to buy new fuel lines for Sagaris.

Can anyone advise the best spec/ suppler for these at all? These are from tank to filter, filter to rail etc.

Thanks in advance

[TVR Tommy]

I've under taken this job on my T350. Went down the route of PTFE braided hose. I used chemical resistant heat shrinking to go over the lines to protect powder coating from being rubbed off. Then AN-6 fittings direct from tank, fuel filter and fuel rail removing all rubber from system. Deleted the charcoal canister on the return also.

I was refurbishing the chassis, so body was lifted at the time and had plenty of room to work out the routing. I think it would be a struggle of a job with body in place. Clearance along the top of the chassis is tight with added difficulty of the insulation blanket being in the way.

[TVR Tommy]

Just noticed your name and seen your other thread on the rebuild. So nice and easy for you. I can probably put together a list of what you need to do the job.

[Dave85chim]

Hi Tommy

Thanks for your message, I would certainly welcome a steer in direction regarding the parts you used.

Also if you have any images of the routing of them them - that would be useful.

Regards,
Dave