help seat belt bong bong bong
Discussion
ok i know it is there to save my life but when i am reversing i can't hear my park sensors ,yes i know if i put my seat belt on it will stop but when i backing out the garage i think its a bit stupid to have to put your seatbelt on so you can hear your sensors 
must be some way of disconnecting them ?
must be some way of disconnecting them ?Method 1 - Per Journey Disable:
Turn the ignition on and within three seconds fasten and then unfasten the seat belt. This disables the alarm until the ignition is turned off.
Method 2 - Permanent Disable:
This method is slightly peculiar, yet is it the official way of disabling the warning chimes! Start with the handbrake on and in neutral. Ensure all doors are closed, the drivers seatbelt is unbuckled and the exterior lights off.
* Insert the into the ignition and turn to position 2 (The one before engine start). Wait for the seatbelt warning light to go out (Depending on the installed software this can take up to 2 minutes) Within 60 seconds of the light going out you need to:
* Buckle and unbuckle the seatbelt 3 times (ending with the seatbelt unbuckled).
* Turn on headlights - turn off again
* Buckle and unbuckle the seatbelt 3 times (ending with the seatbelt unbuckled) - The seatbelt light should illuminate for 3 seconds
* Within 7 seconds of seatbelt warning light going off, slowly buckle then unbuckle seatbelt
This will disable/enable "Beltminder". The warning light cannot be disabled and will light (If disabled) for 3 secs. If the system is enabled the seatbelt light will light for 3 secs, every 3 secs.
Turn the ignition on and within three seconds fasten and then unfasten the seat belt. This disables the alarm until the ignition is turned off.
Method 2 - Permanent Disable:
This method is slightly peculiar, yet is it the official way of disabling the warning chimes! Start with the handbrake on and in neutral. Ensure all doors are closed, the drivers seatbelt is unbuckled and the exterior lights off.
* Insert the into the ignition and turn to position 2 (The one before engine start). Wait for the seatbelt warning light to go out (Depending on the installed software this can take up to 2 minutes) Within 60 seconds of the light going out you need to:
* Buckle and unbuckle the seatbelt 3 times (ending with the seatbelt unbuckled).
* Turn on headlights - turn off again
* Buckle and unbuckle the seatbelt 3 times (ending with the seatbelt unbuckled) - The seatbelt light should illuminate for 3 seconds
* Within 7 seconds of seatbelt warning light going off, slowly buckle then unbuckle seatbelt
This will disable/enable "Beltminder". The warning light cannot be disabled and will light (If disabled) for 3 secs. If the system is enabled the seatbelt light will light for 3 secs, every 3 secs.
Gassing Station | Ford | Top of Page | What's New | My Stuff