Motorbike Advice
Discussion
James, Why not ast on Biker Banter? If I was you I'd also try visordown.com and I'm sure there must be a community specifically for you bike out there.
It might also be worth getting your hands on a Haynes manual.
I've got an abba stand if you need to borrow it. You'll just need to get hold of a fitting kit specific to your bike.
It might also be worth getting your hands on a Haynes manual.
I've got an abba stand if you need to borrow it. You'll just need to get hold of a fitting kit specific to your bike.
James, Why not ast on Biker Banter? If I was you I'd also try visordown.com and I'm sure there must be a community specifically for you bike out there.
It might also be worth getting your hands on a Haynes manual.
I've got an abba stand if you need to borrow it. You'll just need to get hold of a fitting kit specific to your bikem
Edited to add, I thought you said it was a CBR 400, not a CB 400.
It might also be worth getting your hands on a Haynes manual.
I've got an abba stand if you need to borrow it. You'll just need to get hold of a fitting kit specific to your bikem
Edited to add, I thought you said it was a CBR 400, not a CB 400.
Edited by phillvr6 on Sunday 27th January 18:19
At the handle bar lever you should be ablt to move the lever slightly before it starts to move the cable.
Look at where the cable locates in the lever and passes through the clamp.
you should have about 4 or 5 mm gap between the clamp and lever before the lever at the other end of the starts to move IFKWIM.
If you have no slack in the cable adjust the cable to get the right gap.
If the cable is too tight, when the clutch get hot it will be too tight on the cable and not get the full clamping effect from the springs.
if the cable is OK it might be worth dropping the cover of the side of the motor to check the plates and that the ring of bolts have been tightened properly.
I had those bolts come loose on an old kawasaki and it made one hell of a mess of the cover,
Worth buying a Haynes manual!
HTH
Look at where the cable locates in the lever and passes through the clamp.
you should have about 4 or 5 mm gap between the clamp and lever before the lever at the other end of the starts to move IFKWIM.
If you have no slack in the cable adjust the cable to get the right gap.
If the cable is too tight, when the clutch get hot it will be too tight on the cable and not get the full clamping effect from the springs.
if the cable is OK it might be worth dropping the cover of the side of the motor to check the plates and that the ring of bolts have been tightened properly.
I had those bolts come loose on an old kawasaki and it made one hell of a mess of the cover,
Worth buying a Haynes manual!
HTH
Edited by odyssey2200 on Sunday 27th January 20:58
Gassing Station | Thames Valley & Surrey | Top of Page | What's New | My Stuff