Anyone competent with a welder?
Discussion
Hello!
Random question I know, but having just bought 4 lovely new barstools for my new kitchen I was very upset to find out that they are too tall and are good as useless. As you can see here
So rather than sell/bin them I would like to try and shorten them.
However I don't have access to or any experience welding.
So would someone fancy some beer money to chop about 25cm out of the legwork of these then weld back together? Additionally I would love you forever and ever.
They are stainless steel, and here is a generic Internet pic to show whole thing
Let me know
Thanks
:-)
Random question I know, but having just bought 4 lovely new barstools for my new kitchen I was very upset to find out that they are too tall and are good as useless. As you can see here
So rather than sell/bin them I would like to try and shorten them.
However I don't have access to or any experience welding.
So would someone fancy some beer money to chop about 25cm out of the legwork of these then weld back together? Additionally I would love you forever and ever.
They are stainless steel, and here is a generic Internet pic to show whole thing
Let me know
Thanks
:-)
NormanD said:
looks as if more than a Inch off to get the seet low enough
I would just cut the botton off in cluding the link back to front
Then fit some rubber bungs over the cuts
Not a bad idea, but would prefer to do it properly so you can't even tell (they are a "designer" style so would look a bit wrong) but as a last resort it's an option! I would just cut the botton off in cluding the link back to front
Then fit some rubber bungs over the cuts
And I said about 25cm not an inch
Gassing Station | Thames Valley & Surrey | Top of Page | What's New | My Stuff